Publishing House SB RAS:

Publishing House SB RAS:

Address of the Publishing House SB RAS:
Morskoy pr. 2, 630090 Novosibirsk, Russia



Name:
Authors:
Keywords:
Abstract:
   

Thermophysics and Aeromechanics

2012

Number: 3

30691.
Digital particle flow visualization methods as applied to characterization of turbulent boundary layer

A.V. Bilsky1, O.A. Gobyzov1, V.I. Kornilov2, D.M. Markovich3
1 Kutateladze Institute of Thermophysics SB RAS
2 Khristianovich Institute of Theoretical and Applied Mechanics SB RAS
3 Kutateladze Institute of Thermophysics SB RAS; Novosibirsk State University
dmark@itp.nsc.ru
Keywords: optical methods, PIV, PTV, flow visualization, velocity field, pulsations, turbulent boundary layer, flat plate
Pages: 351-362

Abstract >>
In the present paper, we discuss various approaches to measurement of velocity fields and velocity fluctuations in incompressible turbulent boundary layer by digital particle flow visualization methods. In particular, performing measurements in the vicinity of streamlined surface is considered. A description of the optical measuring system and methods to seed the flow with tracer particles is presented. Measured data for flow velocity fields and turbulent velocity pulsations in boundary layer on a flat impermeable plate are analyzed. Comparative data illustrating the efficiency of various algorithms for treating PTV images are presented.



Number: 3

30692.
Gasdynamic design of a two-dimensional supersonic inlet with the increased flow rate factor

YU.P. Gounko, I.I. Mazhul
Khristianovich Institute of Theoretical and Applied Mechanics SB RAS
gounko@itam.nsc.ru, mazhul@itam.nsc.ru
Keywords: gasdynamic design, two-dimensional inlets, numerical computations, high supersonic velocities, flow-rate and efficiency characteristics
Pages: 363-379

Abstract >>
A two-dimensional inlet of external compression with the increased flow rate factor at high supersonic velocities is constructed by the method of gasdynamic design. Its feature is that a flow with the initial oblique shock wave and the subsequent centered isentropic compression wave is formed over the external compression ramp of the inlet. These waves interact with one another so that a resulting stronger oblique shock wave and a velocity discontinuity arise in front of the entrance to the inlet internal duct. An example of an inlet configuration with the design flow regime corresponding to the Mach number Md = 7 is considered. The characteristics of this inlet were obtained in the range of the free-stream Mach numbers M = 4−7 with the use of a Navier-Stokes code for turbulent flow. They are compared with characteristics of an equivalent conventional shocked inlet. As computations have shown, the inlet with the isentropic compression wave has much higher values of flow rate factor ϕ at Mach numbers М < Md. So, for example, at М = 4 the value ϕ ≈ 0.72 for it is by 33 % higher in comparison with ϕ ≈ 0.54 for the equivalent shocked inlet.



Number: 3

30693.
Numerical quadrature for the Prandtl-Meyer function at high temperature with application for air

T. Zebbiche, M. Boun-jad
University SAAD Dahleb of Blida
z_toufik270169@yahoo.fr
Keywords: supersonic flow, high temperature, Prandtl?Meyer function, Gauss?Legendre quadrature, relative error
Pages: 381-384

Abstract >>
When the stagnation temperature of the combustion chamber or ambient air increases, the specific heats and their ratio do not remain constant any more, and start to vary with this temperature. The gas remains perfect, except, it will be calorically imperfect and thermally perfect. A new generalized form of the Prandtl⎯Meyer function is developed, by adding the effect of variation of this temperature, lower than the threshold of dissociation. The new relation is presented in the form of integral of a complex analytical function having an infinite derivative at the critical temperature. A robust numerical integration quadrature is presented in this context. The classical form of the Prandtl-Meyer function of a perfect gas becomes a particular case of the developed form. The comparison is made with the perfect gas model for aim to present a limit of its application. The application is for air.



Number: 3

30694.
Mixing in a T-shaped micromixer at moderate Reynolds numbers

A.V. Minakov1, V.YA. Rudyak2, A.A. Gavrilov1, A.A. Dekterev1
1 Kutateladze Institute of Thermophysics SB RAS; Siberian Federal University
2 Kutateladze Institute of Thermophysics SB RAS; Novosibirsk State University of Architecture and Civil Engineering
valery.rudyak@mail.ru
Keywords: microchannels, micromixers, mixing efficiency, hydrodynamic modelling, slip on walls, Dean vortices
Pages: 385-395

Abstract >>
In the present work, the regimes of the flow and mixing of fluids in a T-shaped micromixer in the range of the Reynolds numbers from 1 to 1000 are investigated systematically with the aid of numerical modeling. The flow and mixing regimes are shown to alter substantially with increasing Reynolds numbers. Five different flow regimes have been identified in the total. The dependencies of the friction coefficient and mixing efficiency on the Reynolds number are obtained. A sharp increase in the mixing efficiency at a flow transition from the symmetric to asymmetric steady regime is shown. On the other hand, the mixing efficiency slightly drops in the laminar-turbulent transition region. A substantial influence of the slip presence on walls on flow structure in the channel and mixing efficiency has been revealed.



Number: 3

30695.
Impact of acoustic oscillations on thermal tornado stability

A.O. Belousova, A.N. Golovanov, I.V. Matveev
Tomsk State University
mivvas@mail.ru
Keywords: thermal tornado, tornado decay, acoustic field
Pages: 397-402

Abstract >>
This paper presents physical modeling of thermal tornado under lab conditions. For the tested range of 0÷300 Hz, selective frequencies were discovered which facilitate the tornado decay. Data analysis was comp-lemented by velocity profile measurement using LDV system LD-05M. The results on velocity pulsation at selected points were recalculated into coefficient of correlation between velocities and function cos(2π f Δti) describing the acoustic oscillations. In the theoretical part of this paper, we present solution of dispersive equation of Euler's model and resulting boundary of stability for tornado existence. Satisfactory agreement between experiment and calculation has been observed.



Number: 3

30696.
Optimizing parameters of GTU cycle and design values of air-gas channel in a gas turbine with cooled nozzle and rotor blades

A.M. Kler, YU.B. Zakharov
Melentiev Institute of Power Engineering Systems SB RAS
contain@mail.ru
Keywords: gas turbine, parameters optimization, cooling scheme
Pages: 403-413

Abstract >>
The authors have formulated the problem of joint optimization of pressure and temperature of combustion products before gas turbine, profiles of nozzle and rotor blades of gas turbine, and cooling air flow rates through nozzle and rotor blades. The article offers an original approach to optimization of profiles of gas turbine blades where the optimized profiles are presented as linear combinations of preliminarily formed basic profiles. The given examples relate to optimization of the gas turbine unit on the criterion of power efficiency at preliminary heat removal from air flows supplied for the air-gas channel cooling and without such removal.



Number: 3

30697.
Numerical simulation of steady cavitating flow of viscous fluid in a Francis hydroturbine

L.V. Panov1, D.V. Chirkov1, S.G. Cherny1, I.M. Pylev2, A.A. Sotnikov2
1 Institute of Computational Technologies SB RAS
2 JCS Power Machines, LMZ Branch
chirkov@ict.nsc.ru, cher@ict.nsc.ru
Keywords: numerical simulation, cavitation, hydraulic turbines
Pages: 415-427

Abstract >>
Numerical technique was developed for simulation of cavitating flows through the flow passage of a hydraulic turbine. The technique is based on solution of steady 3D Navier-Stokes equations with a liquid phase transfer equation. The approch for setting boundary conditions meeting the requirements of cavitation testing standard was suggested. Four different models of evaporation and condensation were compared. Numerical simulations for turbines of different specific speed were compared with experiment.



Number: 3

30698.
About lack of fragmentation for hot droplets at low subcooling of coolant

YU.P. Ivochkin, S.N. Vavilov, YU.A. Zeigarnik, K.G. Kubrikov
Joint Institute for High Temperatures RAS
vortex@iht.mpei.ac.ru
Keywords: liquid metal, vapor explosion, pressure, fragmentation
Pages: 429-434

Abstract >>
It was confirmed in experiments that during contact between cool and hot liquids, the lower subcooling of the cool liquid below the saturation temperature changes the characteristics of a vapor layer covering the fragments of hot liquid. This factor also decreases the probability of spontaneous direct contact between two kinds of liquid, explosive incipience of the cool liquid, and pressure pulse generation (the latter triggers fine fragmentation of hot coolant and vapor explosion). The mechanism that describes this trend in vapor layer behavior has been described.



Number: 3

30699.
Emission of Аg2 dimers from a substrate during vacuum deposition of the mixture of silver and water vapor

A.A. Bochkarev, V.I. Polyakova
Kutateladze Institute of Thermophysics SB RAS
anaboch@itp.nsc.ru
Keywords: sorption, nucleation, dimers, fluctuation, dimers emission
Pages: 435-447

Abstract >>
The work presents calculation of Ag2 dimers emission from the substrate into the vapor medium in case of joint deposition of silver and water vapors on ideal substrate formally modeling the crystal of water ice in terms of energy properties. It is assumed that the dimers are formed on the condensation surface as a result of random collisions of atoms at their surface migration, and the dimers emission is conditioned by thermal fluctuations of crystal lattice of water ice. The calculations based on the modified Langmuir adsorption model allowed concluding that emission of silver and water dimers takes place in the entire range of the studied water vapor pressure, binding energy of silver-water, and crystal temperature. Dynamics of emission from the beginning of deposition and dependence of dimers emission on micro-roughness of the condensate surface have been investigated. Statistical processing of results has shown that the probability of dimers emission from the condensate surface is determined not only by the value of the binding energy between the dimer and condensate but by configuration of the nearest dimer environment on the condensation surface. It has been found that there is a certain value of micro-roughness of condensation surface providing the maximal intensity of dimer emission. Dimers emission from the surfaces bordering on the flows of vapor mixtures contaminates the flows with unsuspected admixtures. The latter one makes investigation of this phenomenon important for aeromechanics of vapor and gas mixtures.



Chemistry for Sustainable Development

2011

Number: 1

30700.
Carbon Sorbents in Medicine and Proteomics

L. G. Pyanova
Institute of Hydrocarbons Processing, Siberian Branch of the Russian Academy of Sciences
medugli@ihpp.oscsbras.ru
Keywords: carbon sorbents, sorptional medicine, proteomics
Pages: 107-116

Abstract >>
Hemosorption (purifying the blood outside an organism) and enterosorption (detoxification of an organism through the gastrointestinal tract) are the most promising methods of the sorptional medicine. As far as the adsorption of toxic substances with different molecular mass and nature is concerned, carbon sorbents are of interest to meet the requirements of medicine. Sorbents of different nature and structure are described. Methods for controlling the adsorption activity of the sorbent are indicated. A particular attention is paid to the development of selective sorbents for using in sorptional medicine and proteomics.




Articles 30691 - 30700 of 31229
First | Prev. | 3068 3069 3070 3071 3072 | Next | Last | All