The stability of the Couette - Poiseuille flow of a monodisperse mixture is considered. Sufficient stability conditions are derived. Results of the computation of the spectrum are presented. A considerable stabilization of the flow with particles admixture to small disturbances is observed. It is found that the regions of instability generation may have complex geometry. The influence of the main velocity profile and admixture parameters on the stability conditions is considered.
D.PH. Sikovsky
Kutateladze Institute of Thermophysics SB RAS; Novosibirsk State University dphs@itp.nsc.ru
Keywords: turbulence, particle-laden flows, particle deposition, asymptotic theory
Pages: 235-254
On the basis of the previously developed asymptotic theory of turbulent particle-laden flow with particle deposition in channels coupled with the transport model for the particle Reynolds stress, an asymptotic solution to the problem on the deposition of particles in the limit of high Reynolds numbers was obtained. The numerical calculations confirmed the presence, in the region of the transition from the diffusion-impaction regime of particle sedimentation to the inertia-moderated regime, bifurcation phenomenon of a solution found previously in earlier studies. Features of particle accumulation in the viscous sublayer are analyzed. On the basis of the numerical solution, correlations for particle deposition velocity were obtained. Boundary conditions of the wall-function type for particle concentration whose use allows widening the applicability limits of the equilibrium Eulerian models in terms of particle inertia are proposed.
Laboratory samples of small-sized energy converters based on thermo-electric method of heat conversion which source is diffusion microflame are presented in the work. Processes of combustion, energy conversion, and cooling in the proposed systems have been experimentally studied. Relatively high efficiency of the studied systems (energy-conversion 0.8 % at generated electric power of 130 mW) complying with the current world level for such devices is shown. The advantages of the proposed power generators are absence of forced-cooling system and catalysts, assemblage simplicity and usage of available materials and components. On the basis of investigation results, possible ways of further improvement of test samples have been determined with the view of energy conversion efficiency increase.
Filtration and separation properties were studied for filters made from open-porosity ceramics (sintered from authors-developed silicon dioxide nanopowder tarkosil". Key parameters were measured for samples of ceramics produced at different sintering temperatures: porosity, gas permeability coefficient, relative time of standard volume fill-up, gas mixture separation coefficient. The possibility of using the described ceramics for helium enrichment was demonstrated with examples of helium-nitrogen and helium-methane mixtures.
The modification of electrodiffusional method of the wall shear stress measurements is applied for registration of the Taylor bubble shear stress in an upward liquid flow. Time realization of shear is considered as a structure frozen into the flow, which moves together with a bubble. Experiments were carried out in laminar and transitional liquid flows. The wall shear stress in the liquid film around bubble averaged over the tube perimeter is presented for different flow Reynolds numbers and different lengths of the bubble.
E.V. Sereshchenko1, R.V. Fursenko1, S.S. Minaev1, V.N. Kurdyumov2 1 Khristianovich Institute of Theoretical and Applied Mechanics SB RAS 2 Energy Department of CIEMAT minaev@itam.nsc.ru
Keywords: microcombustion, instability, ignition
Pages: 293-304
The thermal-diffusive model was applied to the problem of flame propagation in a microchannel with controlled temperature distribution in the walls; this demonstrated the possibility of formation of oscillating or rotating spatial flame structures, which were described previously in experimental works on microcombustion. Two cases were considered: combustion in a rectangular channel and in the clearance between two disks with radial feeding of premixture. In both cases, the typical across size of the channel was lower than the critical diameter determined with respect to the ambient temperature. The gas flow was assigned and described by the Poiseuille-flow velocity profile. Formation of oscillating flame in a rectangular channel and rotating patterns in a radial channel was observed for a certain range of gas flow rate. At low flow rates beyond this range, repetitive ignition/extinction of flame took place; at high flow rate we observed a steady flame mode. Formation of these special flame structures is related to heat transfer between gas and hot walls of the channel, as well as to velocity maldistribution in the microchannel.
Dependence of spectral and energy characteristics of cesium plasma radiation on electric power PL has been found. It is shown that with PL growth metal vapor pressure increases; transformation of spectral structure of radiation manifested in disappearance of individual lines and increase of steady monotone takes place. Redistribution of average radiation power in individual spectral ranges is observed.
Hyun-seo park
Jeonju University hnsepark@unitel.co.kr
Keywords: plasma melting, incineration ash, dioxins, environment, chemical compound, heavy metals, leaching
Pages: 313-321
The paper presents the investigation of plasma melting of the mixed bottom and fly incineration ash at various mixing ratios of the components. Chemical compound of the bottom and fly ash as well as the slag after its melting was analyzed by different methods, and the content of toxic components in them was determined. It is demonstrated that the direct disposal of the fly and bottom incineration ash may cause dioxin and heavy metal contamination of the environment. The influence of melted ash basicity on the resulting slag compound was studied. The mass balance of the melting process was defined. The tests were performed to determine the heavy-metals leaching from the ash and slag. It is also shown that the slag after plasma melting is dioxin-free and environmentally friendly.
N.N. Mezentseva
Kutateladze Institute of Thermophysics SB RAS mezn@itp.nsc.ru
Keywords: non-azeotropic refrigerants, heat pump, energy conversion ratio
Pages: 323-330
The work presents the results of cycle computation for vapor compression pumps based on ozone-safe mixed refrigerants. Non-azeotropic binary refrugerants R32/R152а (30/70) and R32/R134а (30/70) were considered as working substances. Properties of non-azeotropic refrigerants were calculated according to the additivity method of thermodynamic functions and method of Lemmon and Jacobsen. Deviations in the values of thermophysical properties obtained with two methods have been determined. It is shown that at the use of non-azeotropic mixture R32/R152a (30/70), energy conversion ratio increases by 2.2−3.6 % compared with the results for R32/R134a (30/70) at temperature difference between the processes of boiling and condensation from 28 to 53 °С.
On April 13, 2011 Chief researcher of Lavrentiev Institute of Hydrodynamics SB RAS, Doctor of Physics and Mathematics, Professor Vladimir B. Kurzin was 80 years of age.