Publishing House SB RAS:

Publishing House SB RAS:

Address of the Publishing House SB RAS:
Morskoy pr. 2, 630090 Novosibirsk, Russia



Name:
Authors:
Keywords:
Abstract:
   

Thermophysics and Aeromechanics

2009

Number: 2

30931.
Strategy of a choice of single-layer compliant coatings for turbulent drag reduction

B.N. Semenov
Kutateladze Institute of Thermophysics SB RAS, boris_n_semenov@mail.ru
Keywords: drag reduction, compliant coating
Pages: 219-228

Abstract >>
The main principles and methods of developing the single-layer monolithic compliant coatings for turbulent drag reduction are presented.



Number: 2

30932.
Study of turbulent swirling flow in a rotating separation element of variable cross section

P.N. Zyatikov1, A.T. Roslyak2, G.V. Kuznetsov3
1 Tomsk State University
2 Tomsk State University
3 Tomsk State University, roslyakat@ignd.tpu.ru
Keywords: Turbulent swirling flow, separation zone, initial swirling, channel contour, circumferential and radial velocity components, experimental setup, cylindrical probe, gas-powder flow
Pages: 229-238

Abstract >>
In the present study, the distribution of circumferential velocity components of carrier flow in separation elements of air-centrifugal classifiers of powder materials has been experimentally examined. The study was carried out for variously contoured separation channels, and also for various conditions of a carrying agent (air) input in a separation zone. Optimal conditions for particle separation throughout the whole volume of the separation element can be organized by making the channel contour diverging towards the center of rotation. The experimental data gained in this study supplement the mathematical model for the aerodynamics of turbulent carrier flow in the shaped rotating separation elements of air-centrifugal classifiers and make an analysis of the separation-zone flow possible.



Number: 2

30933.
Adiabatic evaporation of binary liquid mixtures on the porous ball surface

V.I. Terekhov1, N.E. Shishkin2
1 Kutateladze Institute of Thermophysics, SB RAS, terekhov@itp.nsc.ru
2 Kutateladze Institute of Thermophysics, SB RAS, shishkin@itp.nsc.ru
Keywords: heat transfer, binary mixtures, adiabatic evaporation, sphere
Pages: 239-245

Abstract >>
Measured data for the temperature of a porous spherical surface to which an evaporating binary liquid mixture was supplied are reported. In the experiments, solutions of ethyl and methyl alcohols in water, and also solutions of acetone in water, were used. The concentration of mixture components was varied throughout the widest possible range of XL = 0−1, and the temperature of dry air flow past the sphere was in the range t0 = 15−300 °C. In the present study, a strong influence of the composition of the mixtures on their adiabatic evaporation temperature was established. In the heat- and mass-transfer process, the air temperature is also of paramount importance. An experimental correlation is obtained which generalizes data on adiabatic evaporation temperature in a broad range of component concentrations and temperatures for the experimentally examined binary liquid mixtures.



Number: 2

30934.
Modelling of change of the classifier separation characteristics by water injection into the apparatus

J.G. Dueck1, E.V. Pikushchak2, L.L. Minkov3
1 Erlangen−Nurnberg University
2 Tomsk State University, Pikushchak@ftf.tsu.ru
3 Tomsk State University
Keywords: classifier, injection, sedimentation, polydisperse suspension, particle interaction, numerical modeling
Pages: 247-258

Abstract >>
The investigation of the influence of additional water injection in a classifier on the particle separation process characteristics has been performed on the basis of numerical modelling. It has been shown that the increase in water injection velocity leads to the increase of both the cut size and the minimal value of separation curve. The change of the injector opening size influences only the minimum value of the separation function not altering the cut size at the specified water injection velocity.



Number: 2

30935.
Detonation waves in bubble-drop media

A.I. Sychev
Lavrentyev Institute of Hydrodynamics SB RAS, sychev@hydro.nsc.ru
Keywords: detonation wave, multicomponent media, bubble media, drop media, bubble-drop media, liquid, gas bubbles, liquid drops
Pages: 259-265

Abstract >>
Wave processes in chemically active multicomponent media: liquid ⎯ gas bubbles ⎯ liquid drops have been studied experimentally. Existence of detonation waves in multicomponent (bubble-drop) media has been proved. Structure of detonation waves in bubble-drop and bubble media is qualitatively identical: detonation waves are solitary waves with pulsation profile the pressure behind which is close in value to the one in unperturbed medium. Propagation velocity of detonation waves in bubble and bubble-drop media drops with the increase in medium gas phase concentration and with the decrease in carrier liquid viscosity. Presence of liquid drops decreases detonation wave velocity compared with bubble medium that does not contain liquid drops. Detonation wave propagation in multicomponent media causes gas bubbles fragmentation as well as fragmentation of individual liquid drops.



Number: 2

30936.
Thermal conductivity and thermal diffusivity of the R134a refrigerant in the liquid state

A.V. Baginsky1, A.S. Shipitsyna2
1 Kutateladze Institute of Thermophysics SB RAS, gamma@itp.nsc.ru
2 Kutateladze Institute of Thermophysics SB RAS
Keywords: thermal conductivity, thermal diffusivity, R134a, liquid state, method of high-frequency thermal waves
Pages: 267-273

Abstract >>
Thermal conductivity and thermal diffusivity of "ozone-safe" refrigerant R134а in liquid state within the range of temperatures 295.9−354.9 K and pressures from the liquid ⎯ vapor equilibrium line up to 4.08 MPa have been studied by high-frequency thermal-wave method. The experimental uncertainties of temperature, pressure, thermal conductivity and thermal diffusivity measurement errors were estimated to be 0.1 K, 3 kPa, 1.5 and 2.5 %, respectively. Values of thermal conductivity and thermal diffusivity of liquid R134а on saturated line have been calculated. Approximation dependences for thermal conductivity and thermal diffusivity within the whole studied range of temperatures and pressures as well as on the saturated line have been obtained.



Number: 2

30937.
Influence of the intensity of chemical heat-release source on the heat exchange at a flow of pseudo-plastic liquid in the initial interval of coaxial duct

B.R. Abaidullin
Research Center of Power Engineering Problems of the Kazan Scientific Center of RAS, cyberincorp@mail.ru
Keywords: dissipative source, structurally viscous liquid, critical regimes of heat exchange, activation energy of chemical reaction
Pages: 275-281

Abstract >>
The critical regimes of heat exchange at a laminar steady flow of a pseudo-plastic liquid in the initial interval of a coaxial duct are investigated with regard for both dissipative and chemical sources in the Arrhenius representation [5] under the conditions of an insignificant variation of the concentrations of reacting substances.



Number: 2

30938.
Non-stationary radiative-conductive heat transfer in a layer with partially absorbing boundaries

N.A. Rubtsov1, S.D. Sleptsov2
1 Kutateladze Institute of Thermophysics SB RAS, sleptsov@itp.nsc.ru
2 Kutateladze Institute of Thermophysics SB RAS
Keywords: radiative-conductive heat transfer, coefficients of absorption, reflection, and transmission, semitransparent medium
Pages: 283-289

Abstract >>
Here we consider one-dimensional heating of a layer of gray semitransparent medium by an outer source of radiation and convection. The sample boundaries reflect, absorb (radiate), and transmit radiation. It is shown that heating dynamics and character of temperature fields depend significantly on optic parameters of the boundaries.



Number: 2

30939.
Numerical modelling of the work of a pulsed aerosol system for fire fighting at the ignitions of liquid hydrocarbon fuels

A.D. Rychkov
Institute of Computational Technologies SB RAS Novosibirsk State University, rych@ict.nsc.ru
Keywords: numerical modelling, gas burning, two-phase turbulent flows, fire fighting
Pages: 291-301

Abstract >>
The work of a pulsed aerosol system for fire fighting is modelled, which is designed for fire fighting at oil storages and at the spills of oil products, whose vapors were modelled by gaseous methane. The system represents a device for separate installation, which consists of a charge of solid propellant (the gas generator) and a container with fine-dispersed powder of the flame-damper substance. The methane combustion was described by a one-stage gross-reaction, the influence of the concentration of vapors of the flame-damper substance on the combustion process was taken into account by reducing the pre-exponent factor in the Arrhenius law and was described by an empirical dependence.
The computational experiment showed that the application of the pulsed aerosol system for fire fighting ensures an efficient transport of fine-dispersed aerosol particles of the flame-damping substance and its forming vapors to the combustion zone; the concentration of particles ensures the damping of the heat source.



Number: 2

30940.
Exergy analysis of ramjet

A.F. Latypov
Khristianovich Institute of Theoretical and Applied Mechanics SB RAS, latypov@itam.nsc.ru
Keywords: exergy, diagram, ramjet, heat supply condition, pulsed-periodic energy supply
Pages: 303-313

Abstract >>
An exergy analysis of possible regimes of energy supply to the air flow in the ramjet duct is carried out. A condition for the supply of a given heat amount to supersonic flow and a condition of the passage across the sound velocity are obtained for a duct with variable cross-sectional area. An analysis of the flow in a model ramjet duct at a pulsed-periodic energy supply is carried out. For a clear demonstration of possible schemes of heat supply in such a duct, a diagram in the temperature-exergy coordinates is proposed. A duct configuration in which the heat supply to supersonic flow is realized with regard for the limitation of the gas static temperature is proposed.




Articles 30931 - 30940 of 31229
First | Prev. | 3092 3093 3094 3095 3096 | Next | Last | All