Publishing House SB RAS:

Publishing House SB RAS:

Address of the Publishing House SB RAS:
Morskoy pr. 2, 630090 Novosibirsk, Russia



Name:
Authors:
Keywords:
Abstract:
   

Thermophysics and Aeromechanics

2009

Number: 1

31011.
Estimation of energetic efficiency of heat supply in front of the aircraft at supersonic accelerated flight. Part II. Mathematical model of the trajectory boost part and computational results

A.F. Latypov
Khristianovich Institute of Theoretical and Applied Mechanics SB RAS, Novosibirsk, Russia
Keywords: free stream heating, planning flight, efficiency, scramjet, exergy method, optimal trajectory
Pages: 1-12

Abstract >>
The fuel economy was estimated at boost trajectory of aerospace plane during energy supply to the free stream. Initial and final velocities of the flight were given. A model of planning flight above cold air in infinite isobaric thermal wake was used. The comparison of fuel consumption was done at optimal trajectories. The calculations were done using a combined power plant consisting of ramjet and liquid-propellant engine. An exergy model was constructed in the first part of the paper for estimating the ramjet thrust and specific impulse. To estimate the aerodynamic drag of aircraft a quadratic dependence on aerodynamic lift is used. The energy for flow heating is obtained at the sacrifice of an equivalent decrease of exergy of combustion products. The dependencies are obtained for increasing the range coefficient of cruise flight at different Mach numbers. In the second part of the paper, a mathematical model is presented for the boost part of the flight trajectory of the flying vehicle and computational results for reducing the fuel expenses at the boost trajectory at a given value of the energy supplied in front of the aircraft.



Number: 1

31012.
Analysis of supersonic flow around two bodies of revolution near a surface

E.K. Derunov1, V.F. Volkov2, A.A. Zheltovodov3, A.I. Maksimov4
1 Khristianovich Institute of Theoretical and Applied Mechanics SB RAS, Novosibirsk, Russia
2 Khristianovich Institute of Theoretical and Applied Mechanics SB RAS, Novosibirsk, Russia
3 Khristianovich Institute of Theoretical and Applied Mechanics SB RAS, Novosibirsk, Russia, zhelt@itam.nsc.ru
4 Khristianovich Institute of Theoretical and Applied Mechanics SB RAS, Novosibirsk, Russia
Keywords: shock waves, turbulent boundary layer, viscous-inviscid interaction, separated zones, flow topology, aerodynamic interference, Euler equations
Pages: 13-36

Abstract >>
The results of experimental and numerical investigations of the peculiarities of flow around two identical cylindrical bodies of revolution of diameter D = 50 mm and the body aspect ratio λ = 5 with conical forebodies whose apex angles are θ = 40° and 60°, which are located above a horizontal surface in parallel with one another and with the flow, are presented for the Mach numbers М∞ = 4.03, Reynolds numbers Re1 ≈ 55⋅106 m−1, fixed distance from the surface Y = Δy/D = 0.96, and the gaps between their axes Z = Δz/D = 1.06−2.4. The peculiarities of three-dimensional turbulent separated flows realizing on the bodies and on the plate as well as the possibilities of predicting the aerodynamic forces and moments acting on the bodies on the basis of numerical computations within the framework of the Euler equations are considered.



Number: 1

31013.
Influence of small angles of attack and sweep on the rolling moment at a hypersonic flow around the bodies of revolution

YU.A. Mokin
State Rocket Center Makeyev Construction Bureau, Miass, Russia, src@makeyev.ru
Keywords: hypersonic flow, body of revolution, small variations of surface, angle of attack, rolling moment
Pages: 37-42

Abstract >>
The influence of small attack and sweep angles on the rolling moment variation at a supersonic flow around the bodies close to the bodies of revolution is considered. Based on the method of the differential hypothesis of locality the integral expressions are obtained for the derivatives of the rolling moment coefficient with respect to the attack and sweep angles. The norm of these derivatives is defined and the estimates for the norm are obtained.



2008

Number: 4

31014.
Criterion of homogeneous boiling-up of superheated liquids

G.V. Ermakov1, E.V. Lipnyagov2
1 Institute of Thermal Physics UB RAS, Ekaterinburg, Russia, ermakov-german@mail.ru
2 Institute of Thermal Physics UB RAS, Ekaterinburg, Russia
Keywords: waiting time for boiling-up of superheated liquid, theory of homogeneous stationary nucleation, theoretical and empirical work of critical nucleus formation
Pages: 667-675

Abstract >>
It is difficult to eliminate the effect of vessel walls and impurities in practical studies of boiling-up of strongly superheated liquids. Therefore, some doubts are always cast upon validity of experiments and their agreement with the classical theory of homogeneous stationary nucleation, impairing the verification of theoretical considerations. This paper reports main results of the theory of homogeneous nucleation and presents formulas for calculating the work of formation of a critical nucleus by an incline of the accessible superheating boundary on isobars and isotherms. Matching of experimental and theoretical values of the work of formation was considered as the homogeneous boiling-up criterion. Calculations by isobars and isotherms were made for some liquids. The theoretical values of the work of formation of a critical nucleus were 1.23-4.5 times higher than the corresponding empirical values for all the liquids, i.e., they were much higher than the calculation error. Thus, boiling-up of the studied liquids was not homogeneous and, hence, it did not correspond to the classical theory of nucleation.



Number: 4

31015.
Numerical and analytic investigation of the dynamics of hollow droplet impact onto substrate

A.N. Cherepanov1, O.P. Solonenko2, V.V. Bublik3
1 Khristianovich Institute of Theoretical and Applied Mechanics SB RAS, Novosibirsk, Russia
2 Khristianovich Institute of Theoretical and Applied Mechanics SB RAS, Novosibirsk, Russia
3 Khristianovich Institute of Theoretical and Applied Mechanics SB RAS, Novosibirsk, Russia, ancher@itam.nsc.ru
Keywords: hollow metal droplet, substrate, impact, mathematical model
Pages: 677-688

Abstract >>
A numerical and analytical model is proposed for the impact of a hollow melt droplet onto the surface of a solid polished substrate. The model is based on integral laws of the mass and energy conservation of the colliding droplet, it accounts for capillary and adhesion properties of the melt. The main parameters of the high-velocity deformation of a hollow particle have been computed: the variation of its height, shell thickness, and the contact spot diameter up to the moment of the spreading droplet solidification as well as the pressure variation inside the droplet until the moment of the shell rupture. The critical pressure value at which the rupture occurs is estimated by a formula characterizing the spherical shell strength. Quite a fair agreement of the computed values of the final diameter of the splat of a spread and solidified droplet with the data of physical experiment  is shown.



Number: 4

31016.
Mathematical modelling of damp porous material drying in diffusion approximation

U.R. Ilyasov1, D.E. Igoshin2
1 Nizhnevartovsk Branch of Southern-Ural State University, Nizhnevartovsk, Russia
2 Sterlitamak State Teacher Training Academy, Sterlitamak, Russia, navydimka@rambler.ru
Keywords: mathematical modelling, drying, heat and mass transfer, vapor, water, volumetric moisture content, porosity, diffusion, thermal conductivity, self-similar problem, shooting
Pages: 689-697

Abstract >>
The problem of drying a porous permeable material is considered. Self-similar solutions are derived for the process of the moisture diffusion transport. The dependence of drying intensity on the porous medium initial state as well as on the parameters of external effect is investigated.



Number: 4

31017.
On the mathematical modeling of processes of peat firing and smoldering

A.N. Golovanov1, A.S. Yakimov2, A.A. Abramovskikh3, YA.R. Sukov4
1 Tomsk State University, Tomsk, Russia
2 Tomsk State University, Tomsk, Russia, YakimovAS@mail.ru
3 Tomsk State University, Tomsk, Russia
4 Institute of Monitoring of Climatic and Environmental Systems SB RAS, Tomsk, Russia
Keywords: peat, drying, water, pyrolysis, friction
Pages: 699-710

Abstract >>
Based on a mathematical model of a porous reacting medium the statement and mathematical solution are presented for a problem of the peat smoldering rise as a result of the effect of a lower seat of fire. It is found that at moderate temperatures T ≤ 750 K the firing and smoldering of the initial reagent are determined by the intensity of the external burning seat as well as by the processes of the peat drying, pyrolysis, and the oxidation reaction of the coked fixed bed.



Number: 4

31018.
Analysis of the properties of heat radiation of the axisymmetric semitransparent systems with permeable boundaries

N.A. Rubtsov1, S.D. Sleptsov2
1 Kutateladze Institute of Thermophysics SB RAS, Novosibirsk, Russia
2 Kutateladze Institute of Thermophysics SB RAS, Novosibirsk, Russia, sleptsov@itp.nsc.ru
Keywords: heat radiation, semitransparent medium, permeable boundaries
Pages: 711-719

Abstract >>
Numerical analysis of hemispherical values of absorptive, transmitting, and reflective abilities of a flat layer and absorptivity of a sphere is presented in this paper depending on the optic thickness and refractive index.



Number: 4

31019.
Development of carbon-carbon nozzle extension for liquid fuel rocket motors

a:2:{s:4:"TYPE";s:4:"HTML";s:4:"TEXT";s:108:"M.I. Sokolovsky1, S.N. Petukhov2, YU.P. Semyonov3, B.А. Sokolov4";}
1 SPA "Iskra", Perm, Russia
2 SPA "Iskra", Perm, Russia
3Korolev RSC "Energy", Moscow, Russia
4 Korolev RSC "Energy", Moscow, Russia, iskra@iskra.perm.ru
Keywords: liquid fuel rocket motor (LFRM), carbon-carbon extension
Pages: 721-727

Abstract >>
Successful experience of RSC "Energy" and SPA "Iskra" in the development of carbon-carbon extension for oxygen-kerosene liquid fuel rocket motor has been summarized. Methodological approach that served to completion of carbon-carbon extension development in full and at comparatively small expenses has been described. Results of practical application of carbon-carbon extension for liquid fuel rocket motor 11D58М have been presented within the framework of International Space Program "Sea Launch".



Number: 4

31020.
Thermal conductivity and thermal diffusivity of tantalum at in the temperatures range from 293 to 1800 K

I.V. Savchenko1, S.V. Stankus2
1 Kutateladze Institute of Thermophysics SB RAS, Novosibirsk, Russia, gamma@itp.nsc.ru
2 Kutateladze Institute of Thermophysics SB RAS, Novosibirsk, Russia
Keywords: laser flash method, tantalum, thermal conductivity, thermal diffusivity, high temperatures
Pages: 729-732

Abstract >>
Thermal diffusivity of polycrystalline tantalum at the temperatures range from 293 to 1800 K has been measured by the laser flash method with the error of 2−4 %. Thermal conductivity has been calculated with the use of reference data on density and heat capacity. Approximating equations and tables of reference data for the temperature dependence of heat transfer coefficients have been obtained; comparison with the published data has been carried out.




Articles 31011 - 31020 of 31229
First | Prev. | 3100 3101 3102 3103 3104 | Next | Last | All